Post Jobs

EEPROM 95160 PDF

STMicroelectronics MW Series EEPROM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for STMicroelectronics . Errors and solutions here for eeprom read/write with Carprog programmer: Error 1: “ID not found” when read eeprom EEPROM, Serial SPI, 16 Kbit, 2K x 8bit, 10 MHz, SOIC, 8 Pins The M WMN6P is a 16Kbit (2K x 8bit) serial SPI bus EEPROM (Electrically Erasable.

Author: Nern Meztilabar
Country: Mauritania
Language: English (Spanish)
Genre: Environment
Published (Last): 13 July 2017
Pages: 288
PDF File Size: 11.68 Mb
ePub File Size: 2.2 Mb
ISBN: 584-9-70345-422-8
Downloads: 65147
Price: Free* [*Free Regsitration Required]
Uploader: JoJokora

Reply 8 benaknoun Spain Posts.

Reply 9 ZLM Posts. Reply 6 benaknoun Spain Posts.

MCUmall EPROM BIOS Chip Burner Forum – 8pin

Hi, it seems i’m doing something right then! Reply 17 ZLM Posts.

Reply 7 ZLM Posts. Reply 13 benaknoun Spain Posts. Reply 2 benaknoun Spain Posts. When you uploading the image, only use letter and number as file name.

Carprog 9.31 reads/writes eeprom 95160 with A4/A6 adapter

Once the chip is blank, then you can load your data file and click on Write button to wrtie the data into chip. But the fast way is to remove it from board and program it on the programmer ZIF spcket directly.

  AN INTRODUCTION TO THEORIES OF PERSONALITY HERGENHAHN PDF

Which part number you selected in software? Reply 11 benaknoun Spain Posts. Reply 5 ZLM Posts. Reply 14 benaknoun Spain Posts. Reply 19 ZLM Posts. It should be able to open it by same software. Device blank check failed at address: Most of used on-board chips should have something. That is depending on your circuit design.

Reply 4 benaknoun Spain Posts. Reply 1 ZLM Posts. I believe they will do the job.

The only way to test data is: Then the ADP should be used. So, if you can not read anything out, make sure your pins have good contacting. You can save data as. Eepom the chip is not designed for programming in circuit, then you need to try to find some connection. Reply 18 benaknoun Spain Posts. It is SOIC8 mil chip. I think it should be SOIC8 mil chip.

Carprog reads/writes eeprom with A4/A6 adapter | OBDIIcom Official Blog

Reply 3 ZLM Posts. What is your chip on board? Hi, ok forget this chip, its damaged Also, another question please about the same chip: The “Device blank check failed ” means the chip is not a blank chip, there are some data in the chip. Reply 12 ZLM Posts. Also, when i click on ID, it says “function not supported on this device” Image Insert: Hi, i have connected the tool to the chip and adapter to the programmer.