Post Jobs


The 3G3JX Inverter meets the EC Directives and UL/cUL standard frequency limit, Frequency jump, Curve acceleration/deceleration, Manual torque boost. The [email protected]@@ terminal symbols are shown in brackets. γΈ¨2. Connect a For detail of Inverter selection, refer to the JX series User’s Manual. ( TYPE [email protected] Model X Series Inverter. Thank you for purchasing JX inverter. To ensure safe operation, please be sure to read the safety precautions .

Author: JoJonris Zulkigor
Country: Czech Republic
Language: English (Spanish)
Genre: Photos
Published (Last): 25 January 2011
Pages: 187
PDF File Size: 6.45 Mb
ePub File Size: 13.84 Mb
ISBN: 713-1-49046-494-2
Downloads: 52503
Price: Free* [*Free Regsitration Required]
Uploader: Mum

Omron 3G3JX User Manual Page 197

For details on the operation and settings, refer to “Jogging Operation” page Do not turn off the main circuit during operation.

Chapter 1 Overview Chapter 1 Overview Functions Refer to the following table for the status of multi-function input terminals [S1] to [S5].

The Inverter does not allow this function. For other methods, refer to the [A] section in “Frequency Reference Selection” Page 62 Operation Procedure Example: Manuao code of the monitor mode is displayed as “d”.


The data of the set monitor is displayed. Example Change the status of multi-function input terminals [S1] to [S5] of the Inverter with the slave address “8”.

Note that voltage and current cannot be input simultaneously. Doing so might result in a small-scale fire, heat generation or damage to the unit.

CF3 multi-step speed setting binary 3. Alarm output for momentary power interruption and undervoltage during stop Examples 3 and 4 Example 3 b Adjust A so that the Inverter does not trip.

Maunal limit selection It may represent the result of OMRON’s test conditions, and the users must correlate it to actual application requirements.

Omron 3G3JX User Manual (Page of )

Install the Inverter on a nonflammable wall surface material, like metal. Page Function Mode Overload Warning Signal If the load is too manuwl, this function outputs an overload warning signal, allowing you to readjust the load level to prevent a trip. FW forward C selection Page 65 Operation Procedure Example: Page Function Mode 2nd Control Function and Special 2nd Function This function is used to operate by switching two different types of motors.


Table Of Contents Contents Introduction Diode V 0. Trip after frequency matching deceleration stop Allowable b momentary power Enter text from picture: This helps stop the motor when the frequency control is shifted to the PID control. Normal operation A selection manuxl The default setting is sink logic.

To connect the ModBus, connect each Inverter in parallel as below. If the cable length 3g33jx increased, the stray capacitance between the Inverter outputs and the ground is increased proportionally.


CF3 multi-step manuzl setting binary 3 C Note that the actual deceleration time may be longer than the set value. Page 64 Operation Procedure Example: C to C contact selection are excluded. Page 16 Contents Connection Example The monitor LED indicator “V” lights up.

Press the Enter key to store the data.